Installation [11/2018 - ]: Procedure

INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
1. Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.
  Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf)
INSPECT REAR AXLE HUB BEARING LOOSENESS
See step 7
INSPECT REAR AXLE HUB RUNOUT
See step 8
INSTALL REAR DISC
Refer to PROCEDURE - Step 1
INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Refer to PROCEDURE - Step 2
INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
1. Install the rear disc brake caliper assembly to the rear axle beam assembly with the 2 bolts.
  Torque: 72 N*m (734 kgf*cm, 53 ft.*lbf)
CONNECT SKID CONTROL SENSOR WIRE
Refer to PROCEDURE - Step 11
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
See step 11

NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [11/2018 - ]
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 3
ADJUST PARKING BRAKE PEDAL TRAVEL
Refer to ADJUSTMENT [06/2015 - ]
INSTALL REAR WHEEL
Refer to PROCEDURE - Step 1
CHECK FOR SPEED SENSOR SIGNAL
Refer to TEST MODE PROCEDURE [06/2015 - ]
INSPECT REAR WHEEL ALIGNMENT
Refer to INSPECTION [06/2015 - ]