Installation [06/2015 - 11/2018]: Procedure
- INSTALL REAR AXLE HUB AND BEARING ASSEMBLY
- Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.
Torque: 90 N*m (918 kgf*cm, 66 ft.*lbf)
- Install the rear axle hub and bearing assembly to the rear axle beam assembly with the 4 bolts.
- INSPECT REAR AXLE HUB BEARING LOOSENESS
See step 7
- INSPECT REAR AXLE HUB RUNOUT
See step 8
- INSTALL REAR DISC
Refer to PROCEDURE - Step 1
- INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Refer to PROCEDURE - Step 2
- INSTALL REAR DISC BRAKE CALIPER ASSEMBLY
- Install the rear disc brake caliper assembly to the rear axle beam assembly with the 2 bolts.
Torque: 72 N*m (734 kgf*cm, 53 ft.*lbf)
- Install the rear disc brake caliper assembly to the rear axle beam assembly with the 2 bolts.
- CONNECT SKID CONTROL SENSOR WIRE
Refer to PROCEDURE - Step 11
- CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
See step 11
- INSTALL LUGGAGE TRIM SERVICE HOLE COVER
Refer to PROCEDURE - Step 3
- ADJUST PARKING BRAKE PEDAL TRAVEL
Refer to ADJUSTMENT [06/2015 - ]
- INSTALL REAR WHEEL
Refer to PROCEDURE - Step 1
- CHECK FOR SPEED SENSOR SIGNAL
Refer to TEST MODE PROCEDURE [06/2015 - ]
- INSPECT REAR WHEEL ALIGNMENT
Refer to INSPECTION [06/2015 - ]
- ADJUST LANE DEPARTURE WARNING CAMERA
Refer to ADJUSTMENT [06/2015 - 11/2018]