Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the FC radiator assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedures	Effect/Inoperative Function When Necessary Procedures are not Performed	Link
Front bumper assembly	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	TOYOTA Parking Assist-sensor System Parking Support Brake System	Refer to CALIBRATION [11/2018 - ]
Disconnect cable from negative auxiliary battery terminal	Perform steering sensor zero point calibration	Lane Control System	Refer to INITIALIZATION [11/2018 - ]
		Parking Support Brake System*1
		Pre-collision System
		Lighting System (EXT)

*1: When performing learning using the Techstream.