LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Mirai >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling System - Service Information >> Cooling Fan Motor >> Installation [06/2015 - ] >> Procedure

Installation [06/2015 - ]: Procedure

  1. INSTALL COOLING FAN WITH CONTROLLER MOTOR 
    1. For No. 2 Fan Side:
      1. Install the cooling fan with controller motor to the fan shroud with the 5 screws.

        Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

        NOTE:

        If the cooling fan with controller motor has been struck or dropped, replace it.

      2. Install the No. 2 fan to the fan shroud with the 3 screws.

        Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    2. For Fan Side:
      1. Install the cooling fan with controller motor to the fan shroud with the 5 screws.

        Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

        NOTE:

        If the cooling fan with controller motor has been struck or dropped, replace it.

      2. Install the fan to the fan shroud with the 3 screws.

        Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

  2. INSTALL FC RADIATOR ASSEMBLY 

    Refer to INSTALLATION [06/2015 - 11/2018] , or refer to INSTALLATION [11/2018 - ] 

scientia non olet · About LEMON Manuals