FC System Indicator Malfunction [06/2015 - ]: Procedure
- CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
- Check for DTCs.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
NG
GO TO CAN COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
Result:
OK
See step 2
- Check for DTCs.
- CHECK FOR DTC (EV CONTROL SYSTEM)
- Check for DTCs.
Refer to DTC CHECK / CLEAR [06/2015 - ]
Powertrain > EV > Trouble Codes
OK
No DTCs are output.
Result
Proceed to OK NG
Result:
NG
GO TO EV CONTROL SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - ]
Result:
OK
See step 3
- Check for DTCs.
- READ VALUE USING TECHSTREAM (HV SYSTEM INDICATOR)
- Using the Techstream, read the Data List.
Refer to DATA LIST / ACTIVE TEST [06/2015 - 01/2018] , or refer to DATA LIST / ACTIVE TEST [01/2018 - 11/2018] , or refer to DATA LIST / ACTIVE TEST [11/2018 - ]
Body Electrical > Combination Meter > Data List
Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note HV System Indicator HV system indicator value Min.: -101%, Max.:511% -101 to 511% - Body Electrical > Combination Meter > Data List
Tester Display EV System Indicator OK
FC system indicator value displayed on the Techstream is almost the same as EV system indicator indication.
Result
Proceed to OK NG
Result:
NG
GO TO EV CONTROL SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - ]
Result:
OK
See step 4
- Using the Techstream, read the Data List.
- CHECK COMBINATION METER ASSEMBLY
- Replace the combination meter assembly.
Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]
- Check that the operation of the FC system indicator returns to normal.
OK
The operation of the FC system indicator returns to normal.
Result
Proceed to OK NG
Result:
OK
END (COMBINATION METER ASSEMBLY IS DEFECTIVE)
Result:
NG
REPLACE EV CONTROL ECU. Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]
- Replace the combination meter assembly.