Wireless Charger Illumination Circuit [06/2015 - ]: Procedure

1. Disconnect the mobile wireless charger cradle assembly connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Front view of wire harness connector (to Mobile Wireless Charger Cradle Assembly)

2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   e1-10 (ILL+) - Body ground	Headlight dimmer switch assembly set to TAIL or HEAD	11 to 14 V
   	Headlight dimmer switch assembly off	Below 1 V

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2015 - ]  

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR