Inspection [06/2015 - ]: Procedure
- INSPECT PARKING BRAKE SWITCH ASSEMBLY
- Check the resistance.
*a Component without harness connected
(Parking Brake Switch Assembly)*b Terminal *c Switch body *d On *e Off - Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.
Standard Resistance
Tester Connection Switch Condition Specified Condition Terminal - Switch body Parking brake switch on
(Switch pin free)Below 1 Ω Parking brake switch off
(Switch pin pushed in)10 kΩ or higher If the value is not as specified, replace the parking brake switch assembly.
- Measure the resistance between the connector terminal and the nut inside the parking brake switch assembly.
- Check the resistance.