Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the power window regulator motor assembly removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Removal/installation of Front door window regulator assembly Removal/installation of Power window regulator motor assembly Removal/installation of Front door glass sub-assembly	Initialize Power Window Control System	Auto up and down function Jam protection function Remote control function Key-off operation function Catch protection function Window open warning function	Refer to INITIALIZATION [06/2015 - ]

HINT:

Use the same procedure for both the RH and LH side.
The procedure described below is for the LH side.