LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Mirai >> Repair and Diagnosis (Single Page) >> Body & Frame >> Seats >> Seats - Service Information >> SEAT CUSHION HEATER (for Rear Side) >> Inspection [06/2015 - ] >> Procedure

Inspection [06/2015 - ]: Procedure

  1. INSPECT SEPARATE TYPE REAR SEAT CUSHION COVER (for LH Side) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY555813Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Separate Type Rear Cushion Cover LH)

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        1 - 2 Always (20 °C (68 °F)) 3.34 to 4.00 Ω
        2 - 3 Always (20 °C (68 °F)) 3.34 to 4.00 Ω

        If the specified condition is not met, replace the separate type rear seat cushion cover (for LH Side).

  2. INSPECT SEPARATE TYPE REAR SEAT CUSHION COVER (for RH Side) 
    1. Check the resistance.
      1. Measure the resistance according to the value(s) in the table below.
        GTY555816Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Component without harness connected
        (Separate Type Rear Cushion Cover RH)

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        1 - 2 Always (20 °C (68 °F)) 3.34 to 4.00 Ω
        2 - 3 Always (20 °C (68 °F)) 3.34 to 4.00 Ω

        If the specified condition is not met, replace the separate type rear seat cushion cover (for RH Side).

scientia non olet · About LEMON Manuals