Installation [06/2015 - ]: Procedure

1. Temporarily install the rear seatback heater (bench type rear seatback cover).

   HINT: 

   • When installing the seat cover, refer to the hints to prevent wrinkles in the rear seatback heater (bench type rear seatback cover).

     Refer to PRECAUTION [06/2015 - ] 

   • In stitch:
     1. As shown in the illustration, adjust the cover seam allowance portions so that they are in the same direction.

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Using hog ring pliers, securely install 22 new hog rings in the order shown in the illustration.
   NOTE:

   • Be careful not to damage or contaminate the rear seatback heater (bench type rear seatback cover).
   • Align the centers of the straps with the center of the rear seatback pad so that wrinkles do not form, and securely fasten the hog rings as shown in the illustration.

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

     *1	Hog Ring
     *a	Hog Ring Pliers

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Using hog ring pliers, securely install 40 new hog rings in the order shown in the illustration, and install the rear seatback heater (bench type rear seatback cover).
   NOTE:

   • Be careful not to damage or contaminate the rear seatback heater (bench type rear seatback cover).
   • Align the centers of the straps with the center of the rear seatback pad so that wrinkles do not form, and securely fasten the hog rings as shown in the illustration.

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

     *1	Hog Ring
     *a	Hog Ring Pliers

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

See step  4

See step  5

HINT: 

Use the same procedure as for the LH side.

See step  7

Refer to INSTALLATION [06/2015 - ]