Inspection [06/2015 - ]: Procedure
- INSPECT BENCH TYPE REAR SEATBACK COVER
- Check the resistance.
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(Bench Type Rear Seatback Cover)Standard Resistance
Tester Connection Switch Condition Specified Condition A-1 (E) - B-3 Always (20 °C (68 °F)) 3.44 to 4.71 Ω A-3 (E) - C-3 Always (20 °C (68 °F)) Below 1 Ω A-5 (LO) - B-2 Always (20 °C (68 °F)) 3.44 to 4.71 Ω A-6 (HI) - B-1 Always (20 °C (68 °F)) Below 1 Ω A-7 (LO) - C-2 Always (20 °C (68 °F)) Below 1 Ω A-8 (HI) - C-1 Always (20 °C (68 °F)) Below 1 Ω If the specified condition is not met, replace the bench type rear seatback cover.
- Measure the resistance according to the value(s) in the table below.
- Check the resistance.