LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Mirai >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Interior Panels / Trim - Service Information >> Instrument Panel Safety Pad >> Disassembly [11/2018 - ] >> Procedure

Disassembly [11/2018 - ]: Procedure

  1. REMOVE NO. 2 INSTRUMENT PANEL WIRE 
    1. Disconnect the connector.
      GTY594290Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the clamps to remove the No. 2 instrument panel wire.
  2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR 
    1. Disengage the claws to remove the automatic light control sensor.
      GTY594289Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE SPARE SWITCH HOLE COVER 
    1. Disengage the claws to remove the spare switch hole cover.
      GTY573263Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE INSTRUMENT MAIN PANEL 
    1. Remove the 6 screws <E>.
      GTY609985Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guides to remove the instrument main panel.
      GTY594296Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE INSTRUMENT PANEL PASSENGER WITHOUT DOOR AIRBAG ASSEMBLY 

    Refer to PROCEDURE - Step 5

  6. REMOVE NO. 1 HEATER TO REGISTER DUCT 
    1. Remove the 5 screws <H>.
      GTY594293Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guides to remove the No. 1 heater to register duct.
      GTY594288Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE NO. 3 HEATER TO REGISTER DUCT 
    1. Remove the 5 screws <H>.
      GTY609983Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guides to remove the No. 3 heater to register duct.
      GTY594286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT 

    HINT: 

    Use the same procedures for the opposite side.

    1. Remove the 3 screws <H>.
      GTY594284Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the guides to remove the No. 1 side defroster nozzle duct.
      GTY594253Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE ANTENNA CORD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  10. REMOVE NO. 4 INSTRUMENT PANEL CUSHION 
    1. Remove the No. 4 instrument panel cushion.
      GTY573261Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE NAVIGATION ANTENNA ASSEMBLY 

    Refer to PROCEDURE - Step 4

  12. REMOVE NO. 3 SIDE DEFROSTER NOZZLE DUCT 

    HINT: 

    Use the same procedure as for the No. 4 side.

  13. REMOVE NO. 4 SIDE DEFROSTER NOZZLE DUCT 
    1. Remove the screw <H> and No. 4 side defroster nozzle duct.
      GTY605253Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals