Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Ultrasonic sensor Front bumper assembly	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intuitive Parking Assist System (w/ Parking Support Brake System) Parking Support Brake System	Refer to CALIBRATION [11/2018 - ]
Ultrasonic sensor	Initialization of ultrasonic sensors	Intuitive Parking Assist System (w/o Parking Support Brake System)	Refer to CALIBRATION [11/2018 - ]