Caution / Notice / Hint
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the rear door adjustment are shown below.
NECESSARY PROCEDURES AFTER PARTS REMOVED / INSTALLED / REPLACED
| Replacement Part or Procedure | Necessary Procedures | Effects / Inoperative when not Performed | Link |
|---|---|---|---|
| Disconnect cable from negative (-) auxiliary battery terminal | Initialize Power Window Control System |
|
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
- Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.
*1 Centering Bolt *2 Standard Bolt - A bolt without a torque specification is shown in the standard bolt chart.