Inspection [06/2015 - ]: Procedure
- INSPECT DOOR UNLOCK SWITCH SUB-ASSEMBLY
- Measure the resistance according to the value(s) in the table below.
*a Door unlock switch sub-assembly in neutral position *b Door unlock switch sub-assembly in unlock position *c 60° *d Component without harness connected
(Door Unlock Switch Sub-assembly)Standard Resistance
Tester Connection Condition Specified Condition 1 - 2 Door unlock switch sub-assembly in nautral position 10 kΩ or higher Door unlock switch sub-assembly in unlock position Below 1 Ω If the result is not as specified, replace the door unlock switch sub-assembly.
- Measure the resistance according to the value(s) in the table below.