Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front door disassembly/reassembly are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Front door window regulator assembly Power window regulator motor assembly Front door glass sub-assembly Front door glass run	Initialize Power Window Control System	AUTO up and down function Jam protection function Remote control function Key-off operation function Catch protection function Window open warning function

WARNING:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Refer to PRECAUTION [06/2015 - ]

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.