Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front door lock removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Front door glass sub-assembly Front door glass run	Initialize Power Window Control System	Auto up and down function Jam protection function Remote control function Key-off operation function Catch protection function Window open warning function	WINDOW / GLASS > POWER WINDOW CONTROL SYSTEM > INITIALIZATION

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.