LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Mirai >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seats - Service Information >> Lumbar Switch >> Inspection [06/2015 - ] >> Procedure

Inspection [06/2015 - ]: Procedure

  1. INSPECT POWER SEAT SWITCH ASSEMBLY 
    1. For Driver Side:
      1. Check the resistance.

        Measure the resistance according to the value(s) in the table below.

        GTY541427Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Hold
        *b Release
        *c Component without harness connected
        (Power Seat Switch)

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        5 (B) - 3 (H) Hold Below 1 Ω
        2 (E2) - 1 (R)
        2 (E2) - 3 (H) OFF
        2 (E2) - 1 (R)
        2 (E2) - 3 (H) Release
        5 (B) - 1 (R)

        If the result is not as specified, replace the power seat switch assembly.

    2. For Front Passenger Side:
      1. Check the resistance.

        Measure the resistance according to the value(s) in the table below.

        GTY541429Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a Hold
        *b Release
        *c Component without harness connected
        (Power Seat Switch)

        Standard Resistance

        Tester Connection Switch Condition Specified Condition
        5 (B) - 1 (H) Hold Below 1 Ω
        2 (E) - 3 (R)
        2 (E) - 1 (H) OFF
        2 (E) - 3 (R)
        2 (E) - 1 (H) Release
        5 (B) - 3 (R)

        If the result is not as specified, replace the power seat switch assembly.

scientia non olet · About LEMON Manuals