Luggage Compartment Door Courtesy Switch Circuit [06/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Luggage Courtesy SW	Luggage compartment door courtesy switch signal	ON or OFF	ON: Luggage compartment door open OFF: Luggage compartment door closed	-

   Body Electrical > Main Body > Data List 

   Tester Display
   Luggage Courtesy SW

   OK

   Normal conditions listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2015 - ]  

Result: 

NG 

See step  2

1. Remove the luggage compartment door lock assembly.

   Refer to REMOVAL [06/2015 - ]

2. Inspect the luggage compartment door courtesy switch built into the luggage compartment door lock assembly.

   Refer to INSPECTION [06/2015 - ]

   OK

   Luggage compartment door lock assembly is normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY. Refer to  REMOVAL [06/2015 - ] 

Result: 

OK 

See step  3

1. Disconnect the 4D instrument panel junction block assembly connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   P27-3 (D+) - 4D-16	Always	Below 1 Ω
   P27-3 (D+) - Body ground	Always	10 kΩ or higher
   P27-2 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Remove the instrument panel junction block assembly.

   Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]

2. Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.

   Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]

3. Measure the resistance according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Component without harness connected (Instrument Panel Junction Block Assembly)

   -

   -

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   4D-16 - MB-4 (LGCY)	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [06/2015 - 11/2018]  , or refer to  REMOVAL [11/2018 - ] 

Result: 

NG 

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY. Refer to  REMOVAL [06/2015 - 11/2018]  , or refer to  REMOVAL [11/2018 - ]