DTC B1583: GPS Signal Unreceived [06/2015 - 01/2018]: Procedure
- CHECK TELEPHONE AND GPS ANTENNA (TELEPHONE ANTENNA ASSEMBLY)
- Check that there are no problems with the telephone and GPS antenna (telephone antenna assembly).
OK
The antenna is not excessively dirty and there are no objects blocking signal reception.
Result
Proceed to OK NG
Result:
NG
REMOVE FOREIGN OBJECT
Result:
OK
See step 2
- Check that there are no problems with the telephone and GPS antenna (telephone antenna assembly).
- REPLACE TELEPHONE AND GPS ANTENNA (TELEPHONE ANTENNA ASSEMBLY)
- Replace the telephone and GPS antenna (telephone antenna assembly).
Refer to REMOVAL [06/2015 - 11/2018]
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Replace the telephone and GPS antenna (telephone antenna assembly).
- CLEAR DTC
- Clear the current and past DTCs.
Refer to DTC CHECK / CLEAR [06/2015 - ]
Result
Proceed to NEXT
Result:
NEXT
See step 4
- Clear the current and past DTCs.
- CHECK FOR DTC
- Drive the vehicle for at least 24 km (15 miles).
HINT:
The manual (SOS) switch red indicator will illuminate at approximately 16 km (10 miles) if the problem still exists.
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and wait for 10 seconds.
- Perform "Health Check" and check for current and past DTCs.
Refer to HEALTH CHECK [06/2015 - 01/2018]
HINT:
Turning the power switch off will clear the current DTC.
If the vehicle is driven approximately 16 km (10 miles) and the problem is still present, the DTC will be stored again.
Result
Result Proceed to DTC B1583 is not output A DTC B1583 is output B
Result:
A
END (TELEPHONE AND GPS ANTENNA [TELEPHONE ANTENNA ASSEMBLY] IS DEFECTIVE)
Result:
B
See step 5
- Drive the vehicle for at least 24 km (15 miles).
- REPLACE DCM (TELEMATICS TRANSCEIVER)
- Replace the DCM (Telematics Transceiver).
Refer to REMOVAL [06/2015 - 01/2018]
NOTE:- The power switch must be off.
- Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
Result
Proceed to NEXT
Result:
NEXT
See step 6
- Replace the DCM (Telematics Transceiver).
- PERFORM PRL UPDATE
- Perform "PRL UPDATE".
Refer to PRL UPDATE [06/2015 - 01/2018]
Result
Proceed to NEXT
Result:
NEXT
PERFORM DCM ACTIVATION. Refer to DCM ACTIVATION [06/2015 - 01/2018]
- Perform "PRL UPDATE".