LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Mirai >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Navigation System - Diagnostic Codes & Symptom Tests (1 Of 2) >> Navigation System >> DTC B15FE: XM Tuner Antenna Disconnected; DTC B15FF: XM Tuner Antenna Short [01/2018 - ] >> Procedure

DTC B15FE: XM Tuner Antenna Disconnected; DTC B15FF: XM Tuner Antenna Short [01/2018 - ]: Procedure

  1. REPLACE ANTENNA CORD SUB-ASSEMBLY (for Navigation Antenna) 
    1. Replace the antenna cord sub-assembly (for navigation antenna) with a new or known good one.

      Refer to REMOVAL [01/2018 - 11/2018] , or refer to REMOVAL [11/2018 - ]

    2. Clear the DTCs.

      Body Electrical > Navigation System > Clear DTCs 

    3. Recheck for DTCs and check that no DTCs are output.

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END 

    Result: 

    NG 

    See step  2

  2. REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY 
    1. Disconnect the No. 2 antenna cord sub-assembly connector from the antenna cord sub-assembly.
      GTY881769Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Front view of wire harness connector
      (to Telephone Antenna Assembly)
      *b Front view of wire harness connector
      (to Antenna Cord Sub-assembly (for Navigation Antenna))
    2. Disconnect the No. 2 antenna cord sub-assembly connector from the telephone antenna assembly.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      I-2 - H-2 Always Below 1 Ω
      I-2a - H-2a Always Below 1 Ω
      I-2 - Body ground Always 10 kΩ or higher
      I-2a - Body ground Always 10 kΩ or higher

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY. Refer to  REMOVAL [01/2018 - 11/2018]  , or refer to  REMOVAL [11/2018 - ] 

    Result: 

    OK 

    See step  3

  3. REPLACE TELEPHONE ANTENNA ASSEMBLY 
    1. Replace the telephone antenna assembly with a new or known good one.

      Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]

    2. Clear the DTCs.

      Body Electrical > Navigation System > Clear DTCs 

    3. Recheck for DTCs and check that no DTCs are output.

      Body Electrical > Navigation System > Trouble Codes 

      OK

      No DTCs are output.

      Result

      Proceed to
      OK
      NG

    Result: 

    OK 

    END 

    Result: 

    NG 

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY. Refer to  REMOVAL [01/2018 - 11/2018]  , or refer to  REMOVAL [11/2018 - ]