Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the DCM (telematics transceiver) removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Disconnect cable from negative (-) auxiliary battery terminal	Perform steering sensor zero point calibration	Lane Control System	Refer to INITIALIZATION [11/2018 - ]
		Parking Support Brake System*1
		Pre-collision System
		Lighting System (EXT)
DCM (telematics transceiver)	Vehicle binding settings Entune communication initialization or Entune usage reactivation procedure Helpnet service start procedure	Entune service Helpnet service Hands-free car phone using the DCM (only when there is a contract for hands-free car phone) Remote service.	Refer to DCM ACTIVATION [01/2018 - ]

*1: When performing learning using the Techstream.

NOTE:

After the power switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.