Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear height control sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replacement Part or Procedure	Necessary Procedure	Effects/Inoperative when not Performed	Link
Rear height control sensor	Vehicle information registration for the headlight light control ECU sub-assembly LH Initialization of the headlight light control ECU sub-assembly LH	Automatic headlight beam level control system	Refer to INITIALIZATION [06/2015 - ]

HINT:

Use the same procedure for RH and LH sides.
The procedure listed below is for LH side.