How To Proceed With Troubleshooting [06/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Result

Result: 

NEXT 

See step  3

1. Measure the auxiliary battery voltage with the power switch off.

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Check if CAN communication DTCs are output.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]

   OK

   CAN communication DTCs are not output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ] 

Result: 

OK 

See step  5

1. Check for DTCs and note any codes that are output.

   Refer to DTC CHECK / CLEAR [06/2015 - ]

   Body Electrical > Combination Meter > Trouble Codes 

2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [06/2015 - ]

   Body Electrical > Combination Meter > Clear DTCs 

3. Recheck for DTCs by simulating the operation indicated by the DTCs.

   Refer to DTC CHECK / CLEAR [06/2015 - ]

   Body Electrical > Combination Meter > Trouble Codes 

   OK

   No DTCs are output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2015 - 01/2018]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [01/2018 - 11/2018]  , or refer to  DIAGNOSTIC TROUBLE CODE CHART [11/2018 - ] 

Result: 

OK 

See step  6

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [06/2015 - 01/2018] , or refer to PROBLEM SYMPTOMS TABLE [01/2018 - 11/2018] , or refer to PROBLEM SYMPTOMS TABLE [11/2018 - ]

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table.	A
   Fault is listed in Problem Symptoms Table.	B

Result: 

B 

PERFORM TROUBLESHOOTING BASED ON PROBLEM SYMPTOM. Refer to  PROBLEM SYMPTOMS TABLE [06/2015 - 01/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [01/2018 - 11/2018]  , or refer to  PROBLEM SYMPTOMS TABLE [11/2018 - ] 

Result: 

A 

See step  7

1. Operation Check.

   Refer to OPERATION CHECK [06/2015 - 11/2018] , or refer to OPERATION CHECK [11/2018 - ] 

2. Terminals of ECU.

   Refer to TERMINALS OF ECU [06/2015 - ]

3. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [06/2015 - 01/2018] , or refer to DATA LIST / ACTIVE TEST [01/2018 - 11/2018] , or refer to DATA LIST / ACTIVE TEST [11/2018 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

END