Diagnosis System [06/2015 - ]
- DESCRIPTION
- Automatic high beam system data and Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and to repair it.
- CHECK DLC3
- Check the DLC3.
Refer to GENERAL INFORMATION [06/2015 - ]
- Check the DLC3.
- INSPECT AUXILIARY BATTERY VOLTAGE
- Measure the auxiliary battery voltage with the power switch off.
Standard voltage
11 to 14 V (IG OFF)
If the voltage is below 11 V, recharge or replace the auxiliary battery.
- Measure the auxiliary battery voltage with the power switch off.
- DIAGNOSIS SYSTEM
- If the automatic high beam system malfunctions, the automatic high beam indicator light turns off and "Headlight System Malfunction Visit Your Dealer" is displayed on the multi-information display.
*a Automatic High Beam Indicator Light *b Multi-information Display HINT:
When the system returns to normal, "Headlight System Malfunction Visit Your Dealer" is no longer displayed on the multi-information display.
- If the automatic high beam system malfunctions, the automatic high beam indicator light turns off and "Headlight System Malfunction Visit Your Dealer" is displayed on the multi-information display.