Green And Red Indicators Do Not Come On When IG-On [06/2015 - ]: Procedure
- HEALTH CHECK
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Perform "Health Check" using the Techstream and check that Telematics (Safety Connect) is listed on "Health Check Result".
Refer to HEALTH CHECK [06/2015 - 01/2018] , or refer to HEALTH CHECK [01/2018 - ]
Result
Result Proceed to "Telematics" is displayed on the Techstream A "Telematics" is not displayed on the Techstream B
Result:
B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [06/2015 - 01/2018] , or refer to PROBLEM SYMPTOMS TABLE [01/2018 - ]
Result:
A
See step 2
- CHECK DTC
- Turn the power switch off.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and wait for 10 seconds.
- Turn the Techstream on.
- Check current DTCs and history DTCs.
Refer to DTC CHECK / CLEAR [06/2015 - ]
Result
Result Proceed to DTCs are not output A DTCs are output B
Result:
A
CHECK FOR INTERMITTENT PROBLEMS. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - 11/2018] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2018 - ]
Result:
B
GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [06/2015 - 01/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [01/2018 - ]