Caution / Notice / Hint

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ultrasonic sensor removal/installation are shown below.

NECESSARY PROCEDURE AFTER PARTS REMOVED/INSTALLED/REPLACED

Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Replacement of front center ultrasonic sensor Replacement of front corner ultrasonic sensor	Measurement of ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intuitive Parking Assist System (w/ Parking Support Brake System) Parking Support Brake System	Refer to CALIBRATION [11/2018 - ]
	Initialization of ultrasonic sensors	Intuitive Parking Assist System (w/o Parking Support Brake System)	Refer to CALIBRATION [11/2018 - ]

HINT:

Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.