Data List / Active Test [11/2018 - ]

DATA LIST

NOTE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.

Enter the following menus: Body Electrical / Central Gateway / Data List.

Body Electrical > Central Gateway > Data List

Tester Display
IG2 SW
IG1 SW
ACC SW
+B Voltage
Number of DTC

According to the display on the Techstream, read the Data List.

Body Electrical > Central Gateway > Data List

Tester Display	Measurement Item	Range	Normal Condition
IG2 SW	Power switch on (IG) signal (IG2 terminal)	OFF or ON	OFF: Power switch on (ACC) or off ON: Power switch on (IG)
IG1 SW	Power switch on (IG) signal (IG1 terminal)	OFF or ON	OFF: Power switch on (ACC) or off ON: Power switch on (IG)
ACC SW	Power switch on (ACC) signal (ACC terminal)	OFF or ON	OFF: Power switch off ON: Power switch on (ACC) or on (IG)
+B Voltage	Auxiliary battery voltage (BATT terminal)	Over 8 V or Under 8 V	Over 8 V: Auxiliary battery voltage 8 V or higher Under 8 V: Auxiliary battery voltage below 8 V
Number of DTC	Number of DTCs	0 to 255	0: Normal