Inspection [06/2015 - 11/2018]: Procedure
- INSPECT NO. 2 ULTRASONIC SENSOR
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected
(No. 2 Ultrasonic Sensor)Standard Resistance
Tester Connection Condition Specified Condition 1 (E) - 2 (S) Always 20 to 40 kΩ - If the result is not as specified, replace the No. 2 ultrasonic sensor.
- Measure the resistance according to the value(s) in the table below.