LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Mirai >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Monitor - Service Information >> ULTRASONIC SENSOR (for Front Side) >> Inspection [06/2015 - 11/2018] >> Procedure

Inspection [06/2015 - 11/2018]: Procedure

  1. INSPECT NO. 1 ULTRASONIC SENSOR 
    1. Measure the resistance according to the value(s) in the table below.
      GTY557403Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 1 Ultrasonic Sensor)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (E) - 2 (S) Always 20 to 40 kΩ
      1. If the result is not as specified, replace the No. 1 ultrasonic sensor.
scientia non olet · About LEMON Manuals