Removal [06/2015 - ]: Procedure

Refer to PROCEDURE - Step 1

1. Remove the 4 screws and front wheel opening extension pad LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using a screwdriver, turn the pin hold clip 90 degrees clockwise to remove the 2 pin hold clips.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Pin Hold Clip	*b	Hexagon Screw
   *c	Grommet	*d	Bolt
   *e	Screw	*f	Clip

2. Using a hexagon socket wrench 4, remove the 2 hexagon screws.
3. Using a clip remover, remove the grommet.
4. Remove the bolt.
5. Remove the 6 screws.
6. Using a clip remover, remove the 7 clips and front fender splash shield sub-assembly LH.

1. Disconnect the connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

2. Using a clip remover, disengage the clamp to remove the wireless door lock buzzer.