LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission (UA80F) - Service Information (1 Of 2) (Except Hybrid)) >> Transmission Control Cable >> Removal [11/2016 - ] >> Procedure

Removal [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 2

  2. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 

    See step  4

  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    See step  5

  4. REMOVE AIR CONDITIONING UNIT ASSEMBLY 

    Refer to REMOVAL [11/2016 - ]

  5. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Separate the transmission control cable assembly from the transmission floor shift assembly.
      GTY448162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, separate the transmission control cable assembly from the transmission floor shift assembly.
      GTY436798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Counterclockwise
    4. Remove the clip from the transmission control shaft lever as shown in the illustration.
      GTY722579Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with the clip from the No. 1 transmission control cable bracket.
      GTY722578Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Using a screwdriver, disengage the 2 claws and disconnect the clip from the transmission control cable assembly.
      GTY444212Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Disengage the transmission control cable assembly from the No. 3 transmission control cable bracket.
      GTY738854Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. Turn back the dash panel insulator.
      GTY438334Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the 3 bolts and pull out the transmission control cable assembly from the cabin.