LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander XLE, FWD >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Power Outlets (Interior) (Service Information) (Except Hybrid) >> Power Outlet Socket >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [12/2013 - ]

  2. REMOVE FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 7 , or refer to PROCEDURE - Step 7

  3. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 8 , or refer to PROCEDURE - Step 8

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH 

    Refer to PROCEDURE - Step 12

  5. REMOVE INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 16

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 17

  7. DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 18

  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 19

  9. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL WITH AIR CONDITIONING CONTROL ASSEMBLY 

    Refer to PROCEDURE - Step 23

  10. REMOVE NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 31

  11. REMOVE FRONT NO. 2 CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 32

  12. REMOVE CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 33

  13. REMOVE FRONT DOOR SCUFF PLATE RH 

    HINT: 

    Use the same procedure as for the LH side.

  14. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH 

    HINT: 

    Use the same procedure as for the LH side.

  15. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH 

    HINT: 

    Use the same procedure as for the LH side.

  16. REMOVE INSTRUMENT PANEL FINISH PANEL END RH 

    Refer to PROCEDURE - Step 40

  17. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 41

  18. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 42

  19. REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT 

    Refer to PROCEDURE - Step 43

  20. REMOVE CENTER LOWER INSTRUMENT PANEL FINISH PANEL 

    Refer to PROCEDURE - Step 48

  21. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY 
    1. Using a screwdriver, disengage the claw and remove the No. 1 power outlet socket assembly as shown in the illustration.

      HINT: 

      Tape the screwdriver tip before use.

      GTY433085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
  22. REMOVE NO. 1 POWER OUTLET SOCKET COVER 
    1. Disengage the 2 claws and remove the No. 1 power outlet socket cover.
      GTY437644Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals