LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander XLE, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System (Interior) - Service Information - (Except Hybrid) >> Vanity Light >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

  1. INSPECT VISOR ASSEMBLY LH 
    1. Apply battery voltage to the connector and check that the vanity light comes on.
      GTY454899Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Visor Assembly LH)

      OK

      Measurement Condition Condition Specified Condition
      Battery positive (+) → 2 (+B)
      Battery negative (-) → 1 (E)      		 Open the mirror cover Vanity light comes on

      If the result is not as specified, replace visor assembly LH.

  2. INSPECT VISOR ASSEMBLY RH 
    1. Apply battery voltage to the connector and check that the vanity light comes on.
      GTY454899Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Visor Assembly RH)

      OK

      Measurement Condition Condition Specified Condition
      Battery positive (+) → 2 (+B)
      Battery negative (-) → 1 (E)      		 Open the mirror cover Vanity light comes on

      If the result is not as specified, replace visor assembly RH.

scientia non olet · About LEMON Manuals