Precaution [12/2013 - 11/2016]
WARNING: This page is about a different variant/trim than selected.
- INITIALIZATION NOTE:
- If the ECM is replaced, register the ECU communication ID for Immobilizer System.
Refer to REGISTRATION [12/2013 - 11/2016]
- Perform Registration (VIN registration) when replacing the ECM.
Refer to REGISTRATION [12/2013 - 11/2016]
- Make sure to perform Reset Memory (A/T initialization), when replacing the automatic transaxle assembly, ECM or engine assembly.
Refer to INITIALIZATION [12/2013 - ]
- When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
System Name See Procedure Parking Assist Monitor System Refer to INITIALIZATION [12/2013 - 11/2016] Power Door Lock Control System Air Conditioning System (for Automatic Air Conditioning System) Air Conditioning System (for Manual Air Conditioning System) Power Back Door System
- If the ECM is replaced, register the ECU communication ID for Immobilizer System.
- WHEN USING TECHSTREAM WARNING:
Observe the following items for safety reasons:
- Before using the Techstream, read the instruction manual.
- Prevent the Techstream cable from being caught on the pedals, shift lever or steering wheel when driving with the Techstream connected to the vehicle.
- When driving the vehicle for testing purposes using the Techstream, 2 persons are required. One is for driving the vehicle, and the other operates the Techstream.