Replacement [12/2013 - 11/2015]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to REMOVAL [12/2013 - 11/2016]

REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

Using SST, remove the transfer extension housing type T oil seal from the transfer assembly.

SST: 09308-00010

NOTE:

Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer assembly until it reaches the position shown in the illustration.

SST: 09325-20010

Standard Depth

1.1 to 1.9 mm (0.0434 to 0.0748 in.)

NOTE:

Do not tilt the transfer extension housing type T oil seal during installation.

Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal.

INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to INSTALLATION [12/2013 - 11/2016]
INSPECT TRANSFER OIL
Refer to ON-VEHICLE INSPECTION [12/2013 - ]