Replacement [11/2015 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to REMOVAL [12/2013 - 11/2016] , or refer to REMOVAL [11/2016 - ]
- REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
- Using SST, remove the transfer extension housing type T oil seal from the transfer extension housing sub-assembly.
- SST: 09308-00010
NOTE:Be careful not to damage the transfer extension housing type T oil seal contact surface or the inside surface of the transfer extension housing type T oil seal.
*1 Transfer Extension Housing Type T Oil Seal
- Using SST, remove the transfer extension housing type T oil seal from the transfer extension housing sub-assembly.
- INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL
- Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer extension housing sub-assembly until it reaches the position shown in the illustration.
- SST: 09325-20010
Standard Depth
9.8 to 10.6 mm (0.386 to 0.417 in.)
*1 Transfer Extension Housing Type T Oil Seal *a Depth NOTE:- Do not tilt the transfer extension housing type T oil seal during installation.
- Do not tap in the transfer extension housing type T oil seal in too far.
- Apply a small amount of MP grease to the lip of the transfer extension housing type T oil seal.
- Using SST and a hammer, install a new transfer extension housing type T oil seal to the transfer extension housing sub-assembly until it reaches the position shown in the illustration.
- INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
Refer to INSTALLATION [12/2013 - 11/2016] , or refer to INSTALLATION [11/2016 - ]
- INSPECT TRANSFER OIL
Refer to ON-VEHICLE INSPECTION [12/2013 - ]