LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Transfer Case (Service Information) (Except Hybrid)) >> TRANSFER CASE FRONT OIL SEAL (for LH Side) >> Replacement [12/2013 - ] >> Procedure

Replacement [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE TRANSFER ASSEMBLY 

    Refer to REMOVAL [12/2013 - 11/2016] , or refer to REMOVAL [11/2016 - ] 

  2. REMOVE TRANSFER CASE OIL SEAL 
    1. Using SST, remove the transfer case oil seal from the transfer assembly.
      GTY441629Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09308-00010 
      NOTE:

      Do not damage the transfer case oil seal contact surface to the transfer assembly.

  3. INSTALL TRANSFER CASE OIL SEAL 
    1. Using SST and a hammer, install a new transfer case oil seal as shown in the illustration.
      GTY454357Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09608-10010 
      • SST: 09950-70010 
        1. 09951-07150

      Standard Depth

      9.5 to 10.5 mm (0.375 to 0.413 in.)

      NOTE:
      • Tap in the transfer case oil seal uniformly so that the transfer case oil seal is straight.
      • Do not tap in the transfer case oil seal in too far.
    2. Apply a small amount of MP grease to the lip of the transfer case oil seal.
  4. INSTALL TRANSFER ASSEMBLY 

    Refer to INSTALLATION [12/2013 - ] 

scientia non olet · About LEMON Manuals