LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 36 (Transfer Case (Service Information) (Except Hybrid)) >> 4WD Control Ecu >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL 4WD ECU ASSEMBLY 
    1. Install the 4WD ECU assembly to the bracket with the nut.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

    2. Connect the 4WD ECU assembly connector.
  2. INSTALL WIRE HARNESS CLAMP BRACKET 

    Refer to PROCEDURE - Step 14 , or refer to PROCEDURE - Step 14

  3. INSTALL INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU 

    Refer to PROCEDURE - Step 2

  4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 32

  5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 40

  6. INSTALL FRONT DOOR SCUFF PLATE LH 

    Refer to PROCEDURE - Step 41

  7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH 

    Refer to PROCEDURE - Step 35

  8. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 34

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [12/2013 - 11/2016] , or refer to INITIALIZATION [11/2016 - ]

scientia non olet · About LEMON Manuals