On-Vehicle Inspection [12/2013 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT COOLING FAN SYSTEM
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Active Test / Control the Electric Cooling Fan.
Powertrain > Engine > Active Test
Tester Display Control the Electric Cooling Fan - Check the operation of the fan while operating it using the Techstream.
If the cooling fan motor does not operate, check the cooling fan circuit.
Refer to Cooling Fan Circuit [12/2013 - ]