LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission (UA80F) - Service Information (1 Of 2) (Except Hybrid)) >> Park / Neutral Position Switch >> Installation [11/2016 - ] >> Procedure

Installation [11/2016 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Move the shift lever to N.
    2. Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts.
      NOTE:

      Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly.

    3. Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.
    4. Turn the transmission control shaft lever clockwise until it stops, then turn it counterclockwise 2 notches.
      GTY703061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a P Position
      *b N Position
    5. Remove the transmission control shaft lever from the park/neutral position switch assembly.
    6. Align the protrusion with the neutral basic line.
      GTY739354Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Neutral Basic Line
      *b Protrusion
    7. Hold the park/neutral position switch assembly in that position and tighten the 2 bolts.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    8. Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut.

      Torque: 12.7 N*m (130 kgf*cm, 9 ft.*lbf) 

    9. Connect the park/neutral position switch assembly connector.
  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Connect the transmission control cable assembly to the transmission control shaft lever and install the clip.
      NOTE:

      Before connecting the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

  3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY 
    1. Engage the guide to the grommet of the air cleaner support bracket to temporarily install the air cleaner case sub-assembly.
    2. Install the air cleaner case sub-assembly with the 2 bolts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

  4. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
    1. Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.
  5. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 3

  6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION 

    See step  2

  7. INSPECT SHIFT LEVER POSITION 

    See step  2

  8. ADJUST SHIFT LEVER POSITION 

    Refer to ADJUSTMENT [11/2016 - ] 

scientia non olet · About LEMON Manuals