LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 21 (Emission Control System (1AR-FE) (Service Information) (Except Hybrid)) >> Purge Valve >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT PURGE VALVE (PURGE VSV) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 23 to 26 Ω

      If the result is not as specified, replace the purge valve (purge VSV).

    2. Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

      OK

      Measurement Condition Specified Condition
      Battery voltage applied between terminals 1 and 2 Air flows from port (F)
      Battery voltage not applied between terminals 1 and 2 Air does not flow
      GTY440286Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Port (E)
      *b Port (F)
      *c Air

      If the result is not as specified, replace the purge valve (purge VSV).

scientia non olet · About LEMON Manuals