Installation [12/2013 - 11/2016]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSTALL TRANSMISSION WIRE
- Install the transmission wire and lock plate to the transmission valve body assembly with the bolt.
Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf)
- Coat the temperature sensor with ATF.
- Install the temperature sensor and lock plate to the transmission valve body assembly with the bolt.
Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf)
- Engage the transmission wire clamp.
- Connect the 7 shift solenoid valve connectors.
- Connect the transmission revolution sensor connector.
- Install the transmission wire and lock plate to the transmission valve body assembly with the bolt.
- INSTALL TRANSMISSION VALVE BODY ASSEMBLY
Refer to INSTALLATION [12/2013 - 08/2014] , or refer to INSTALLATION [08/2014 - 11/2016]