LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Park / Neutral Position Switch >> Adjustment [12/2013 - ] >> Procedure

Adjustment [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Remove the transmission control shaft lever.

      Refer to REMOVAL [12/2013 - ] 

    2. Loosen the 2 bolts of the park/neutral position switch assembly.
      GTY431168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Align the protrusions of the park/neutral position switch assembly.
      GTY429640Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protrusion
    4. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.
      GTY431168Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

      NOTE:

      After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.

    5. Install the transmission control shaft lever.

      Refer to INSTALLATION [12/2013 - ] 

    6. After the adjustment, perform the park/neutral position switch assembly operation check.

      See step  1

scientia non olet · About LEMON Manuals