LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Oil Cooler >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSMISSION OIL COOLER 
    1. Install the transmission oil cooler to the front engine mounting bracket with the 3 bolts.

      Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf) 

    2. Connect the outlet No. 1 oil cooler hose and inlet No. 1 oil cooler hose to the transmission oil cooler and slide the 2 clips to secure them.
    3. Connect the No. 3 water by-pass hose and No. 4 water by-pass hose to the transmission oil cooler and slide the 2 clips to secure them.
  2. ADD ENGINE COOLANT 

    Refer to PROCEDURE - Step 2 , or refer to PROCEDURE - Step 2

  3. ADD AUTOMATIC TRANSAXLE FLUID 

    Refer to ADJUSTMENT [12/2013 - 11/2016] , or refer to ADJUSTMENT [11/2016 - ] 

  4. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  5. INSTALL FRONT FENDER APRON SEAL LH 

    Refer to PROCEDURE - Step 75 , or refer to PROCEDURE - Step 75

  6. INSTALL FRONT FENDER LINER LH 

    Refer to PROCEDURE - Step 77 , or refer to PROCEDURE - Step 77

  7. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 81 , or refer to PROCEDURE - Step 81

  8. INSTALL INLET AIR CLEANER ASSEMBLY 

    Refer to PROCEDURE - Step 52 , or refer to PROCEDURE - Step 52

  9. INSTALL COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 4 , or refer to PROCEDURE - Step 4

  10. INSTALL RADIATOR SIDE SEAL RH 

    Refer to PROCEDURE - Step 5 , or refer to PROCEDURE - Step 5

  11. INSTALL RADIATOR SIDE DEFLECTOR SEAL LH 

    Refer to PROCEDURE - Step 6 , or refer to PROCEDURE - Step 6

scientia non olet · About LEMON Manuals