LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Cooling System (1AR-FE) (Service Information) (Except Hybrid)) >> Radiator >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL RADIATOR ASSEMBLY 
    1. Engage the 3 guides.
    2. Engage the 3 claws to install the fan shroud assembly to the radiator assembly.
      NOTE:

      Do not damage the radiator assembly when installing the fan shroud assembly.

    3. Install the 2 radiator supports to the radiator assembly.
    4. Install the 2 lower radiator supports to the vehicle body.
    5. Install the radiator assembly with the fan shroud assembly to the 2 lower radiator supports.
  2. CONNECT RADIATOR RESERVE TANK HOSE 

    See step  6

  3. CONNECT NO. 2 RADIATOR HOSE 
    1. Connect the No. 2 radiator hose and slide the clip to secure it.
  4. CONNECT NO. 1 RADIATOR HOSE 

    See step  7

  5. INSTALL COOLER CONDENSER ASSEMBLY 

    Refer to INSTALLATION [12/2013 - 11/2016] , or refer to INSTALLATION [11/2016 - ]

  6. ADD ENGINE COOLANT 

    See step  2 , or see step  2

  7. INSPECT FOR COOLANT LEAK 

    Refer to PROCEDURE - Step 1

  8. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 81 , or refer to PROCEDURE - Step 81

scientia non olet · About LEMON Manuals