LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Engine Cooling System (1AR-FE) (Service Information) (Except Hybrid)) >> Cooling Fan Motor >> On-Vehicle Inspection [12/2013 - ] >> Procedure

On-Vehicle Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT COOLING FAN MOTOR 
    1. Disconnect the cooling fan motor connector.
    2. Check that the cooling fan motor operates smoothly when the battery is connected to the cooling fan motor connector.
      GTY440112Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Cooling Fan Motor)
    3. Measure the current while the cooling fan motor is operating.

      Standard Current

      Condition Specified Condition
      Battery voltage applied at 20°C (68°F) 13.6 to 19.6 A

      If the result is not as specified, replace the cooling fan motor.

    4. Connect the cooling fan motor connector.
  2. INSPECT NO. 2 COOLING FAN MOTOR 
    1. Disconnect the No. 2 cooling fan motor connector.
    2. Check that the No. 2 cooling fan motor operates smoothly when the battery is connected to the No. 2 cooling fan motor connector.
      GTY449091Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (No. 2 Cooling Fan Motor)
    3. Measure the current while the No. 2 cooling fan motor is operating.

      Standard Current

      Condition Specified Condition
      Battery voltage applied at 20°C (68°F) 13.6 to 19.6 A

      If the result is not as specified, replace the No. 2 cooling fan motor.

    4. Connect the No. 2 cooling fan motor connector.
scientia non olet · About LEMON Manuals