LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Lubrication System (1AR-FE) (Service Information) (Except Hybrid)) >> Oil Pressure Switch >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Disconnect the engine oil pressure switch assembly connector.
    2. Start the engine.
    3. Measure the continuity of the engine oil pressure switch assembly.
      GTY147711Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard Continuity

      Tester Connection Condition Specified Condition
      1 - Switch body Idling No Continuity
      1 - Switch body Engine stopped Continuity

      If the result is not as specified, replace the engine oil pressure switch assembly.

    4. Connect the engine oil pressure switch assembly connector.
scientia non olet · About LEMON Manuals