LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2019 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System (1AR-FE) (Service Information) (Except Hybrid)) >> Throttle Body >> Inspection [12/2013 - ] >> Procedure

Inspection [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY445465Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Throttle Body with Motor Assembly)

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 (M-) - 2 (M+) 20°C (68°F) 0.3 to 100 Ω

      If the result is not as specified, replace the throttle body with motor assembly.

scientia non olet · About LEMON Manuals