Inspection [12/2013 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT KNOCK CONTROL SENSOR
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
| Tester Connection |
Condition |
Specified Condition |
| 1 - 2 |
25 °C (77 °F) |
120 to 280 kΩ |
If the result is not as specified, replace the knock control sensor.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
| *a |
Component without harness connected
(Knock Control Sensor) |